sauter Equitherm - Service Level; Access to Service Level

EQJW145:
Heating controller
Commissioning
7010015003 A
19
© Fr. Sauter AG
1. Turn the input knob.
2. Select the SERVice parameter you want.
3. Press the input knob.
•
The value of the parameter is shown.
4.
Turn the input knob.
•
The value of the parameter is changed.
5. Press the input knob.
•
The new value is confirmed.
3.3 SERVice level
In SERVice level, a specialist can adapt the basic setting of the EQJW 145 to
the installation so as to meet specific requirements. For this purpose, also
please note the installation instructions enclosed with the EQJW 145
(MV506103).
Incorrect parameterisation (setting) of the heating controller
It can cause major faults on the installation, injuries to people or damage to
the installation.

SERVice mode must only be enabled by a specialist.
Some of the parameters cannot be changed - they can only be viewed
(version number, status information).
3.3.1 Access to SERVice level
1. Set the upper rotary switch to the Service
position.
2. Press the input knob.
3. Turn the input knob.
4. Show the code.
5. Press the input knob.
6. The first SERVice parameter is displayed.
sec
sec
CAUTION!