EQJW145:
Heating controller
Operation
7010015003 A
53
© Fr. Sauter AG
The factory setting for the weekly programme is:
Day Time Mode
Daily 06:00 Normal mode
Daily 22:00 Reduced mode
You are recommended to note any change to the weekly switching
programme in the relevant table in Section 14. Before you can call up, view
or edit the weekly switching programme, you must check whether the bottom
rotary switch is in one of these positions (see 4.1).
Off mode
Continuous heating to normal DHW temperature
Continuous heating to increased DHW temperature
Automatic mode
4.4.1 Calling up the weekly switching programme
1. Set the rotary switch to PROG
2. Push the input knob.
•
The weekly programme is selected.
3. Turn the input knob.
4. Select the day of the week (1=Monday, 2=
Tuesday, 1 - 7 =daily).
5 = Friday has been selected here.
5. Push the input knob.
•
The first switching command for this day
(or for the whole week) is shown.
4.4.2 View switching commands
Turn the input knob.
•
The individual switching commands are
shown. An empty switching command is
shown as '_ _ _ _'.
To Next Page
Loading...
