EQJW145:
Heating controller
Operation
60 7010015003 A
© Fr. Sauter AG
This means that the controller is set to normal hot water mode every night.
This switching command may only be deleted if it is replaced by other
switching commands
4
. You are recommended to note any change to the
weekly switching programme in the relevant table in section 15.
Before you can call up or edit the weekly switching programme, you must
ensure that the top rotary switch is in one of these positions (see 4.1).
Back-up mode
Reduced mode
Normal mode
Automatic mode
4.8.1 Calling up the weekly switching programme
1. Set the bottom rotary switch to PROG
2. Turn the input knob.
3. Select the day of the week (1=Monday, 2=
Tuesday, 1 - 7 =daily).
6 = Saturday has been selected here.
4. Push the input knob.
•
The first switching command for this day
(or for the whole week) is shown.
4.8.2 View switching commands
Turn the input knob. The individual switching
commands are shown. An empty switching
command is shown as '_ _ _ _'.
[Stop].
4
If all the switching commands are deleted, the controller operates continuously with
the increased DHW temperature and the associated special features.
1
x
To Next Page
Loading...
