134
©
Scania CV AB 2011, Sweden
01:03-02
13 Check that the shaft is not loose. Secure
with locking compound 561 200 if it is
loose. First clean thoroughly using a
suitable solvent. Tighten the rotor shaft
using socket wrench 98 421. Tightening
torque 27 Nm.
14 Refit the rotor and rotate it by hand to
make sure it rotates easily.
15 Check the O-ring on the cover of the oil
cleaner housing and fit it. Torque tighten
the lock nut to 15 Nm.
Lubrication system
MASHINESOFT.COM
09120146259
To Next Page
