M 02 Setting Time sec
From 0 to nominal feed rate (see Sequence
and Parameter M 04).
M 03 Feed Distance m
Material path from feeder to end of weighing
platform.
If CPD is active (N 01 = YES) the length from
platform center to point of discharge (N 02)
has to be added.
M05= NO
No entry required.
M 04 Motor STOP Aft. ST YES/NO
Use M 04 to determine whether belt tracking
is desired after completion of batch or after
cut-off.
With slow feeders, tracking helps to avoid
excess feed.
Prerequisite: M 01 = YES
0837
VBW INTECONT PLUS
Details
BV-H2214 GB 96
Technische
Redaktion PDE-RD
Transmission to third parties and reproduction of
this documentation are not permitted. Schenck
Process GmbH reserves all rights of ownership
and copyrights.
To Next Page
Loading...