Display shows
event name e.g. No Release
event code e.g. S2
and a note e.g. Parameter O07.
The note informs the operator of relevant parameter.
TU Let you view various events.
N Return to normal displays.
List of Events
The events are listed in accordance with display
priority.
System messages S1 Memory Error
S2 No Release*
S3 Scale Maintenance ON
S4 Maintenance Interval
Electrics
S7 Simulation active
S9 Host Communication
Electrics E1 Power Failure
E2 Namur Error Tacho*
E3 Namur Error Sensor*
E6 Error Ext. Event
Material flow B1 Out of Tolerance
B4 BATCH Actual Value MAX
Calibration C C1 L/C Input *
C2 Tacho Input *
C3 Belt Skew
C4 Belt Drift
C5 Tare Correction > MAX
C7 ZERO Time
C8 Slip Error
C9 Tare Diff > MAX
Maximum H H1 I > MAX
H2 Load > MAX
H3 v > MAX
H4 L/C Input > MAX
Minimum L L1 I < MIN
L2 Load < MIN
L3 v < MIN
L4 L/C Input < MIN
I = Feed Rate
V = Belt Speed
L/C = Load Cell
* Fault on device or cabling
Contact Outputs
General Alarm available until acknowledged
MIN/MAX Outputs independent of event class,
active also in IGNORE class.
Limit values are reported as long
as event is available and only
with active scale.
0837
INTECONT PLUS VBW
Control
BV-H2214 GB 7
Transmission to third parties and reproduction of
this documentation are not permitted.
SchenckProcess GmbH reserves all rights of
ownership and copyrights.
Technische
Redaktion PDE-RD
1. Event S 2 = O 0 7
No Release
To Next Page
Loading...
Need help?
General
