n
Taring
Designed to zero the basic tare load, the taring
program on principle has the same function as the
zero setting program. However, tare elevation is
not monitored, and the call is protected by
password.
n
Automatic belt influence compensation (BIC)
Using an additional belt circuit sensor and a metal
belt mark, the dynamic zero point influence of the
conveyor belt can be compensated during
operation (with and without material).
This considerably increases the belt weigher’s
short-term accuracy.
n
Measurement at the point of discharge (CPD)
A special speed-dependent delay element shifts
the point of measurement to the material
discharge point where the material amount
discharged is acquired.
n Belt drift display
For prerequisites, see “BIC”.
n Batching mode
(1) Without clearance of conveyor belt.
Controlled is the belt drive motor.
(2) With clearance of conveyor belt.
Controlled is the material prefeeder.
Cut-off point and start of dribble feed can be
adapted automatically in either case.
n
Zero drop out
Used to suppress totalization upon measurements
around zero, for counter to stop while belt is being
unloaded.
Deselect function, if not desired.
n
MIN/MAX messages and outputs
2 separately selectable limit values for monitoring
of signal lamps and relay outputs.
Any event can be reported by message.
MIN/MAX for
(1) Feed rate
(2) Belt load
(3) Belt speed
Switching threshold, relay outputs and event class
can be defined individually for all 6 possibilities.
n
Display filter
Define individually for feed rate, belt load and belt
speed.
n
Maintenance hints
Display event on screen.
(1) Voltage ON-time
(2) Scale ON-time
(3) Zero setting required
n Statistic Process Control (SPC)
Mean values, variances, maximum value storage,
zero settings tables, etc. are available in form of
service values.
n
Adaptions
The electrical system needs not be redesigned,
adapted, etc.
0837
VBW INTECONT PLUS
Characteristics
BV-H2214 GB 30
Technische
Redaktion PDE-RD
Transmission to third parties and reproduction of
this documentation are not permitted. Schenck
Process GmbH reserves all rights of ownership
and copyrights.
To Next Page
Loading...
Need help?
General
