A.16
SEL-387-0, -5, -6 Relay Instruction Manual Date Code 20170601
Firmware and Manual Versions
Instruction Manual
Appendix A
➤ Listed firmware that makes corrections and improvements to the SEL-387-5 (R406 and R306) and the
SEL-387-6 (R401 and R301), with and without DNP.
Appendix D
➤ Corrected data in the A5C0 Relay Definition Block, affecting subsequent pagination.
Appendix G
➤ Corrected DNP instruction list.
20000831
➤ Reorganized and reissued entire manual.
➤ Added information about the SEL-387-6 (R400 and R300).
20000621
Section 5
➤ Corrected Figure 5.23: REF Enable/Block Logic.
➤ Corrected Rows 48 and 49 in Table 5.8: SEL-387 Relay Word Bits and Locations.
Section 6
➤ Made changes to Settings Sheets to reflect changes to firmware.
Section 7
➤ Made changes to reflect changes to firmware.
Section 8
➤ Made changes to reflect changes to firmware.
Appendix A
➤ Updated to reflect the addition of Distributed Network Protocol (DNP) 3.00. (SEL-387-5, R405 and R305)
➤ Changed formatting.
Appendix B
➤ Reordered steps.
Appendix E
➤ Corrected CHISTORY command explanation.
Appendix F
➤ Corrected name of Appendix F: Unsolicited SER Protocol.
Appendix G
➤ Created Appendix G: Distributed Network Protocol (DNP) 3.00.
20000203
Section 2
➤ Corrected typographical errors.
Section 4
➤ Corrected typographical errors.
Section 7
➤ Corrected typographical errors.
Section 10
➤ Corrected typographical errors.
991130
Section 1
➤ Added 24 Vdc and 110 Vdc control input voltage options.
➤ Clarified Type Tests and Standards.
Section 2
➤ Added 24 Vdc and 110 Vdc control input voltage options.
➤ Added relay dimensions and drill plan drawing for panel-mount models (Figure 2.2).
➤ Added rear-panel drawing of model 0387x1, terminal blocks (Figure 2.3).
➤ Moved rear-panel drawing of model 0387xY Connectorized (Figure 2.4).
➤ Changed numbering of figures following Figure 2.2 because of the addition of two figures.
Table A.4 Manual Revision History—SEL-387-5, -6 Relay (Sheet 2 of 3)
Revision Date Summary of Revisions
To Next Page
Loading...