36
4. Basic Operations
6.
Press the Measuring Button ❺ to measure.
The Light Selection Ring
❷
should be set to L ( )
when taking ambient light measurements.
When measuring ash units, select Range L ( )
or Range H ( ) depending on the brightness of
the ash. (
P99,
P101)
Measurements are now displayed.
NOTE
●
It may take longer time in case of taking measurement under low light (under
30lx).
It is not defect that LCD backlight becomes darker while taking
measurement to avoid any inuence.
●
When using the Hue & Saturation function, it is possible for the hue value to
turn from white text to red text. This is an indication that the saturation of the
light measured is too low for an accurate hue measurement. You will nd
this if a light has a saturation below 30%.
7.
Memorize the measurement results.
To record measurements, press Memory Button
❼
. (
P106)
C-800
Light Selection Ring
❷
Measuring Button
❺
To Next Page
Loading...
