Chapter 4 INSTALLATION AND INITIAL SETUP explains how to install the equipment in a rack, and also
how to perform the necessary initial configuration of the Probe management IP address. A step-by-step
quick installation guide is found in section 4.1.
Chapter 5 QUICK SETUP GUIDE contains a quick setup guide; a step-by-step description of how to
setup the Probe once the initial setup has been performed.
Chapter 6 THE PROBE GRAPHICAL USER INTERFACE describes the graphical user interface (GUI) as
seen when pointing a web browser to the Probe’s IP address.
A Appendix: VB220 Versus VBC Alarms describes the alarm handling in the Probe versus the Video-
BRIDGE Controller.
B Appendix: Monitoring Practices explains some useful monitoring practices.
C Appendix: OTT Profile Health explains the OTT profile health bar and timeline.
D Appendix: Software Maintenance briefly describes software maintenance licenses and how they are
used.
E Appendix: Software Upload explains how to upgrade the software on the Probe.
F Appendix: Restoring probe factory defaults details how to reset the Probe to factory default settings.
Note that current version of the User’s Manual can be obtained from Sencore ProCare support by
emailing procare@sencore.com.
14 VB2xx GigE User’s Manual version 5.4
To Next Page
Loading...
Need help?
General
