5 QUICK SETUP GUIDE
This quick setup guide is intended to provide a step-by-step explanation of how to setup a probe once
the initial setup has been performed (as described in chapter 4).
More detailed instructions are found in chapter 6 of this manual.
The Return Data Path and Full Service Monitoring features are not covered by this quick setup guide.
5.1 Basic Setup
1. Set appropriate parameters in the Setup — Params and Setup — Ethernet views.
2.
Enabling Time synchronization is strongly recommended, this can be done in
Setup — Params
.
If no time reference for automatic time locking is available set the time manually in the
Setup —
Time view.
3. If access control is required, define a password and firewall settings in the Setup — Login view.
Note:
it is important to read the instructions in the associated section of this manual, see chap-
ter 6.17.8.
5.2 Input Signal Definitions
5.2.1 ASI Input
1.
Set appropriate parameters in the
ASI — Setup
view. As a start the threshold templates named
Default can be used (for ATSC signals use ATSC Default as the ETR threshold).
5.2.2 Multicasts
1.
Define multicasts, either by using the multicast detect feature (
Traffic — Detect
) or by defining
multicasts manually (Multicasts — Streams).
VB2xx GigE User’s Manual version 5.4 39
To Next Page
Loading...
Need help?
General
