EasyManuals Logo

Sencore VB2 Series User Manual

Sencore VB2 Series
268 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #231 background imageLoading...
Page #231 background image
Enable
management
No Yes
Only run web server on the data/video inter-
face
Gateway 10.0.30.1
The default gateway is required for the
probe to connect to devices that are not
on the same subnet
6.17.5.4 Example 3 Mixed Mode IPv4
This model is similar to the separate management model with the difference that a web server is also run
on the data/video management.
Since there is only one default gateway, in this case pointing to the management network, clients
accessing the probe via the data/video interface need to be on the same subnet as the probe’s data/video
interface.
Parameter Management
(eth1)
Data/video
(eth0)
Explanation
Enable
management
Yes Yes Run web server on both interfaces
The other settings are the same as in example 1
The principles shown in the previous examples also apply for IPv6 management. IPv4 and IPv6 can be
used simultaneously. In theory the probe’s web server can be accessed using four different IP addresses,
provided that the network architecture allows it.
6.17.6 Setup VLANs
The VB220 probe supports a large number of VLAN interfaces. The VLAN interfaces can be associated
with any of the physical interfaces. Once enabled, these VLAN interfaces can be used for routing and
joining of multicasts.
VB2xx GigE User’s Manual version 5.4 231

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sencore VB2 Series and is the answer not in the manual?

Sencore VB2 Series Specifications

General IconGeneral
BrandSencore
ModelVB2 Series
CategoryNetwork Hardware
LanguageEnglish

Related product manuals