SSM
SSM source 1:
If source specific multicasts (SSM) is enabled in the VB220 and a zero source
address is specified for a multicast it will be joined using IGMP version 2 (i.e. without
a source). This allows both source specific multicasts and non-source specific
multicasts to co-exist in the same network and be joined by the VB220.
SSM source 2:
Additional SSM source addresses may be specified to enable back-up solutions.
Note that it is the operator’s responsibility to ensure that a multicast is only transmit-
ted by one SSM source at any time.
SSM source 3: Additional SSM source address
SSM source 4: Additional SSM source address
SSM source 5: Additional SSM source address
ETR (ETR290 Option)
Enable ETR:
ETR monitoring of a stream will not take place unless it is enabled by this
setting. This parameter is only relevant if the probe is ETR enabled.
VB2xx GigE User’s Manual version 5.4 97
To Next Page
Loading...
Need help?
General
