5200 Multi Purpose and 5200 Multi Purpose HF Gas Analysers
05230001A / Revision 9
29
Changing passwords
Use the following procedure to change the supervisor and operator passwords:
1. With the Measurement screen displayed, press the soft key to display the
Menu screen, use the and soft keys to highlight the "Settings" menu
option, then press the soft key. The Settings screen will then be displayed
(see Figure 6).
2. Use the and soft keys to highlight the "Password" menu option, then
press the soft key. The Edit supervisor password screen will then be
displayed with the supervisor password shown, as shown in Figure 12.
Figure 12 - The Edit supervisor password screen
3. To change the supervisor password, press the soft key, then enter the new
password: use the editing method described in Section 4.10.
4. When you enter the last digit, the soft key changes to the soft key.
Press the soft key to enter the new supervisor password value.
5. To change the operator password, press the soft key to display the edit
operator password screen, press the soft key, then enter the new
password: use the editing method described in Section 4.10.
6. When you enter the last digit, the soft key changes to the soft key.
Press the soft key to enter the new operator password value.
7. Press the soft key to display the Settings screen again.
+
If you change a password, ensure that you record the new password
somewhere safe. Otherwise, if you cannot recall the new password, you will
have to contact Servomex or your local Servomex agent for assistance.
To Next Page
Loading...
Need help?
General
