5200 Multi Purpose and 5200 Multi Purpose HF Gas Analysers
05230001A / Revision 966
Date/Time invalid This usually occurs because a Multi Purpose without the
optional rechargeable battery has been left disconnected
from the electrical supply for more than a week. On a
Multi Purpose with the optional rechargeable battery, this
may occur when the battery is empty (fully discharged).
Connect the Multi Purpose to the electrical supply, then
set the date/time as described in Section 5.3.2. If the
fault persists, contact Servomex or your local Servomex
agent for assistance.
Fatal fault Contact Servomex or your local Servomex agent for
assistance.
mA fault (This fault message will only be shown on a Multi
Purpose which has optional milliAmp outputs.)
Ensure that the electrical cabling connected to the Multi
Purpose is not open circuit.
Turn the Multi Purpose off, and then turn it on again. If
the fault persists, contact Servomex or your local
Servomex agent for assistance.
mA not detected (This fault message will only be shown on a Multi
Purpose which has optional milliAmp outputs.)
Contact Servomex or your local Servomex agent for
assistance.
mA reset (This fault message will only be shown on a Multi
Purpose which has optional milliAmp outputs.)
Contact Servomex or your local Servomex agent for
assistance.
Power Config fault Contact Servomex or your local Servomex agent for
assistance.
Fault message Recommended actions
Fault messages (Sheet 2 of 3)
To Next Page
Loading...
