4
Mechanical installation
Setting up the drive unit
Operating Instructions – MOVIMOT
®
advanced
32
4.4.6 Pressure compensation on electronics (option /PE)
Designs with included pressure compensation fitting (option /PE)
On designs with an included pressure compensation fitting (option /PE), install the fit-
ting depending on the mounting position used. The tightening torque is 4.0Nm.
The following table shows the installation positions depending on the mounting posi-
tions:
Mounting positions
Mounting position B5
Mounting is possible in positions X or 2.
32386219403
Mounting positions V1 and V2 only possible after consultation with
SEW‑EURODRIVE.
25891936/EN – 05/2020
To Next Page
Loading...
Need help?
General
