4
Mechanical installation
Setting up the drive unit
Operating Instructions – MOVIMOT
®
advanced
31
Removing the electronics cover
The following figure shows how you can lever off the electronics cover in the intended
places:
25337977611
4.4.3 Installation in damp areas or in the open
Drive units are supplied in corrosion-resistant design for use in damp areas or in the
open. Repair any damage to the paint work if necessary.
4.4.4 Derating depending on the installation altitude
Observe chapter "Technical data and dimension sheets" > "Technical data" > "Derat-
ing factors".
4.4.5 Painting drive units
NOTICE
Breather valves and oil seals may be damaged during painting or re-painting.
Potential damage to property.
• Clean the surface of the drive unit and make sure it is free from grease.
• Thoroughly cover the breather valves and sealing lip of the oil seals with strips
prior to painting.
• Remove the masking strips after painting.
25891936/EN – 05/2020
To Next Page
Loading...
Need help?
General
