5
Electrical installation
Plug connectors
Operating Instructions – MOVIMOT
®
advanced
58
Using third-party cables with plug connectors
If third-party cables are used – even if these cables are technically adequate –
SEW‑EURODRIVE does not accept any liability and cannot guarantee unit properties
or functions.
If you use third-party cables for connecting the device and connected components, en-
sure their compliance with applicable national regulations. Note that the technical fea-
tures of the device or unit network might be affected inadvertently when using third-
party cables. This concerns in particular the following properties:
• Mechanical properties (e.g. IP degree of protection, cable carrier suitability)
• Chemical properties (e.g. silicone and halogen free, resistance to substances)
• Thermal properties (e.g. thermal stability, increase in device temperature, flam-
mability class)
• EMC behavior (such as interference emission limit values, compliance with inter-
ference immunity values stipulated in standards)
• Functional safety (approvals according to ENISO13849-1)
Third-party cables not explicitly recommended by SEW‑EURODRIVE must meet at
least the requirements of the following standards and have been permitted according
to these plug connector standards:
• IEC60309
• IEC61984
25891936/EN – 05/2020
To Next Page
Loading...
Need help?
General
