3-
$2
ii!”
ii
Using Your VIEWCAM Abroad
&
Television system signals and electrical
system voltages and frequencies vary
substantially from country to country.
When you are abroad, please check the
sections below before using the AC adap-
tor or connecting the VIEWCAM to a TV.
Care
Cleaning and maintenance
l Many plastic parts are used in the
VIEWCAM casing. Do not use thinners,
benzenes or other strong chemical
cleaners. These may cause
discoloration and damage to the casing.
@Clean the casing with a soft, dry cloth. If
the casing is particularly dirty, wipe the
casing with a tightly wrung cloth
dampened with a diluted, neutral
detergent. Then wipe it again with a soft,
dry cloth.
*Use a cloth to wipe finger marks and
other soiling off the LCD monitor and
lens protector.
aIf the lens needs cleaning, first remove
the lens protector by turning it anticlock-
wise. Then clean the lens with a cloth, or
compressed air and lens papers
designed for photographic lenses.
The AC adaptor is compatible with 50 Hz
and 60 Hz electrical systems in the range
of 1 IO V to 240 V AC.
This can be used with 12 V and 24 V
negative-ground cars only. Do not use it
with positive-ground electrical systems.
In any country. you can always watch the
video picture by using the LCD monitor
screen. However, if you want to watch the
picture on a TV screen, the TV must be
PAL system compatible. PAL is used in
the following countries:
Germany, Great Britain Sweden, Den-
mark, Austria, Belgium, Switzerland, Italy.
Spain, Holland, Finland, Portugal, Norway,
Hong Kong, Thailand. Australia, New
Zealand, Singapore, Kuwait, China. etc.
Note:
To connect the VIEWCAM to a TV which
does not have audio/video jacks, you
must use the supplied A/V pack and the
optional VR-H30RF or VR-X30RF RF con-
verter (see page 59).
10 fEJ
--
_
To Next Page
Loading...
