SICK nanoScan3 I/O

11.4.1 Data recorder
Overview
Figure 51: Data recorder
Y
ou can use the data recorder to record the device’s signals continuously. The measure‐
ment data are not transmitted and shown for every scan cycle, depending on the inter‐
face and your capacity.
The data is saved in a data recorder diagnostics file.
You can play the data recorder diagnostic file in the data recorder.
Settings can be made in the Safety Designer main window.
Table 25: Data recorder
Start recording
Stop recording
Typical applications
•
Chec
k spatial geometry
•
Check where a person can stay or when a person is detected
•
Check input information about the current monitoring case
•
Check why safety outputs have switched
11 T
ROUBLESHOOTING
106
O P E R A T I N G I N S T R U C T I O N S | nanoScan3 I/O 8024596/15VP/2019-11-15 | SICK
Subject to change without notice