SICK nanoScan3 I/O

7.11 Inputs and outputs, local
Overview
Figure 44: Inputs and outputs, local
1
Overview: plug connector of the safety laser scanner
2
Pin assignment
3
Available signals
4
Remove signal from connection
5
Further settings for some signals
Assign the required signals to the safety laser scanner’s connections in the In
puts and
outputs, local dialog box.
Connection overview
Safety Designer shows the safety laser scanner’s plug connectors and flying leads in
the center of the dialog box.
Pin assignment
The Safety Designer shows the plug connectors with the individual pins and the individ‐
ual wires of the flying leads.
Signals
Safety Designer shows the available signals on the right under Signals.
You can assign the desired signals to the individual pins or wires via drag-and-drop.
7 C
ONFIGURATION
74
O P E R A T I N G I N S T R U C T I O N S | nanoScan3 I/O 8024596/15VP/2019-11-15 | SICK
Subject to change without notice