Important information
DANGER
H
azard due to lack of effectiveness of the protective device
Errors can occur when transferring the configuration to the device, e.g. due to environ‐
mental influences or faulty cables. The verification report always contains the exact set‐
tings stored in the device.
b
Check the configuration report carefully before confirming.
Prerequisites
•
T
he configuration corresponds to the planned safety function and meets the
requirements of the risk assessment.
Approach
1. Click on Identification to ensure that the desired device is connected.
✓
The display of the connected device flashes blue.
2. If the checksums on the computer and the device differ, click Transmit to device.
✓
The transmission process is shown in Safety Designer and on the device.
✓
Safety Designer will notify you as soon as the transfer process is complete.
3. Click Verify.
✓
Safety Designer displays the verification report.
4. Thoroughly review the verification report.
w
If the verification report does not match the planned safety function, click
Cancel, correct the configuration and start again from step 1.
w
If the verification report matches the planned safety function, click Confirm.
✓
Device configuration is shown as verified.
Complementary information
If the configuration is verified, the device automatically starts the safety function after
switching on the voltage supply.
If the configuration is not verified, the safety laser scanner may not be operated as a
protective device. You can start the safety function manually to test the safety laser
scanner and the configuration. The test operation has a time limit.
Further topics
•
"S
tarting and stopping safety function", page 84
7.16 Starting and stopping safety function
In some situations, you can start or stop the safety function manually.
T
able 21: Starting and stopping safety function
Start starts the safety function.
Stop stops the safety function.
7 CONFIGURATION
84
O P E R A T I N G I N S T R U C T I O N S | nanoScan3 I/O 8024596/15VP/2019-11-15 | SICK
Subject to change without notice
To Next Page
Loading...
