SICK nanoScan3 I/O

5 Mounting
5.1 Safety
DANGER
D
angerous state of the machine
b
Make sure that the dangerous state of the machine is (and remains) switched off
during mounting, electrical installation, and commissioning.
b
Make sure that the outputs of the safety laser scanner do not affect the machine
during mounting, electrical installation, and commissioning.
NOTICE
T
he optics cover of the safety laser scanner is an optical component.
b
Do not contaminate or scratch the optics cover during unpacking and mounting.
b
Prevent fingerprints on the optics cover.
5.2 Unpacking
Approach
b
Chec
k components for completeness and integrity for all parts.
b
In the event of complaints, contact the responsible SICK subsidiary.
Further topics
•
"Scope of delivery", page 121
5.3 Fitting the system plug
Prerequisites
T
ool required:
•
TX10 Torx wrench
Approach
1. Carefully insert the system plug into the safety laser scanner.
2.
Screw in the system plug using the captive screws. Tightening torque: 1.3 Nm.
5 MOUN
TING
48
O P E R A T I N G I N S T R U C T I O N S | nanoScan3 I/O 8024596/15VP/2019-11-15 | SICK
Subject to change without notice