SICK nanoScan3 I/O

6 Electrical installation
6.1 Safety
Important information
DANGER
D
angerous state of the machine
b
Make sure that the dangerous state of the machine is (and remains) switched off
during mounting, electrical installation, and commissioning.
b
Make sure that the outputs of the safety laser scanner do not affect the machine
during mounting, electrical installation, and commissioning.
6.2 Connecting
Overview
D
epending on the system plug used, the connection is made via M12 plug connectors
or flying leads.
Prerequisites
•
Project planning has been completed.
•
Mounting is complete.
•
Electrical installation according to project planning.
•
Electrical installation according to the requirements of chapter 4.4, "Integrating
the equipment into the electrical control", page 36.
•
Functional earth is connected correctly.
Further topics
•
"Project planning", page 17
•
"Mounting", page 48
6.2.1 Connecting cable with M12 plug connector, 8-pin
Voltage supply and local inputs and outputs
•
Male connec
tor
•
M12
•
8-pin
•
A-coded
8
2
3
4
5
7
1
6
Figure 34: Connecting cable (male connector, M12, 8-pin, A-coded)
6 ELECTRICAL INSTALLATION
50
O P E R A T I N G I N S T R U C T I O N S | nanoScan3 I/O 8024596/15VP/2019-11-15 | SICK
Subject to change without notice