SICK nanoScan3 I/O

nanoScan3 Core I/O nanoScan3 Pro I/O
Sampling time 4 ms
Response time at EDM after
s
witching on OSSDs (when
used as EDM input)
300 ms
Actuating duration of control
switch for reset (when used
as reset input)
60 ms to 30 s
Actuating duration of switch
for sleep mode (when used
as sleep mode input)
≥ 120 ms
Dynamic control input
Input voltage HIGH 24 V (11 V … 30 V)
Input voltage LOW 0 V (-30 V … 5 V)
Input current HIGH 2 mA … 6 mA
Input current LOW 0 mA … 2 mA
Input capacity Typ. 1 nF
Input frequency ≤ 100 kHz
Duty cycle (Ti/T) 0.5
Analyzable incremental encoders
Type Dual-channel, 90° phase separation
Necessary outputs for incre‐
ment
al encoders
Push-pull
Number of pulses per path ≥ 100 pulses per cm
Length of cable (shielded) ≤ 20 m
1)
The power supply unit must be able to jumper a brief power failure of 20 ms as specified in IEC 60204-1.
Suit
able power supply units are available as accessories from SICK.
2)
The voltage level must not fall below the specified minimum voltage.
3)
Total output current of all outputs ≤ 500 mA.
Table 33: Mechanical data
nanoScan3 Core I/O nanoScan3 Pro I/O
Dimensions (incl. system
plu
g, W × H × D)
106.6 mm × 80.2 mm × 117.5 mm
Weight (including system
plu
g)
0.67 kg
Housing material Aluminum
Housing color RAL 9005 (black) and RAL 1021 (rape yellow)
Optics cover material Polycarbonate
Table 34: Ambient data
nanoScan3 Core I/O nanoScan3 Pro I/O
Enclosure rating
1)
IP65 (IEC 60529)
Ambient light immunity ≤ 40 klx
2)
Ambient operating tempera‐
t
ure
-10 °C … 50 °C
Storage temperature -25 °C … 70 °C
Air humidity ≤ 95%, non-condensing
3)
≤ 95%, non-condensing
4)
13 TECHNICAL DATA
114
O P E R A T I N G I N S T R U C T I O N S | nanoScan3 I/O 8024596/15VP/2019-11-15 | SICK
Subject to change without notice