SICK nanoScan3 I/O

5.4 Mounting the device
Prerequisites
•
Pr
oject planning has been completed.
•
Mount according to project planning.
•
Installation location provides protection against moisture, dirt and damage.
•
Status indicators are easily visible after mounting.
Approach
1
1
Figure 33: Mounting the safety laser scanner
1
Side M5 threaded hole
b
Use all f
our sides of M5 threaded holes for direct mounting, so the values given in
the data sheet for vibration and shock resistance are achieved.
b
Maximum depth of thread engagement: 7.5 mm.
b
Tightening torque: 4.5 Nm … 5.0 Nm.
b
In case of strong vibrations, use screw locking devices to secure the fixing screws.
Complementary information
T
o facilitate mounting and alignment, SICK offers mounting kits as accessories.
Further topics
•
"Project planning", page 17
•
"Dimensional drawings", page 120
•
"Accessories", page 123
MOUNTING 5
8024596/15VP/2019-11-15 | SICK O P E R A T I N G I N S T R U C T I O N S | nanoScan3 I/O
49
Subject to change without notice