•
User de
fined
You can adjust the settings for multiple sampling after switching between monitor‐
in
g cases in line with your requirements for the response time and reliability.
Regardless of the exact settings here, multiple sampling after switching between
monitoring cases is always at least one scan fewer than any other multiple sam‐
pling in place: n
CS
≤ n – 1
7.9 Contour as Reference field
Overview
Figure 40: Contour as Reference field
1
Tool for drawing reference contour fields
2
Drawn contour with tolerance band
3
Contour as Reference field
4
Configure the field
If you have activated the R
eference contour monitoring option for a monitoring plane, the
Reference contour field dialog box is shown.
The reference contour field monitors a contour of the environment. The safety laser
scanner switches all safety outputs to the OFF state if a contour does not match the set
parameters, because, for example, the mounting situation of the safety laser scanner
were changed.
CONFIGURATION 7
8024596/15VP/2019-11-15 | SICK O P E R A T I N G I N S T R U C T I O N S | nanoScan3 I/O
65
Subject to change without notice
To Next Page
Loading...
