10
8014084/ZWT7/V3-1/2020-06 | SICKOPERATING INSTRUCTIONS | TRANSIC111LP
Subject to change without notice
1 IMPORTANT INFORMATION
1 Important information
1.1 Main operating information
Observe the following safety precautions:
CAUTION: The TRANSIC111LP is a protection class 1 laser product
(IEC 60825-1:2014-05).
The TRANSIC111LP is eye-safe when used and operated as intended, because laser
radiation is retained inside the probe as a bundled beam, as shown schematically in
“Probe design and laser beam guidance within the probe”, page 13.
▸ Do not place objects with reflecting surfaces (tools, etc.) directly onto the probe when
the TRANSIC111LP is in operation to prevent the laser beam being reflected out of
the probe.
NOTICE: Protection against electrostatic discharges
▸ SICK products are adequately protected against ESD when used as intended.
▸ Observe the generally valid ESD regulations to avoid damaging the TRANSIC111LP
through electrostatic discharges when touching parts within the enclosure.
WARNING: Hazard through TRANSIC111LP modifications.
Do not remove, add or change any components in or on the device unless such changes
are officially allowed and specified by the manufacturer. Failure to observe these
precautions could result in:
– The manufacturer's warranty becomes void.
– The device could become dangerous.
WARNING: Hazard through device failure
Safe operation of the TRANSIC111LP is questionable when
– The device shows visible damage.
– Moisture has penetrated the device.
– The device has been stored or operated in unallowed ambient conditions.
If safe operation is no longer possible:
▸ Put the TRANSIC111LP out of operation.
▸ Disconnect all connections to the power supply.
▸ Make sure accidental startup is not possible.
To Next Page
Loading...
