CONTENTS
4
8014084/ZWT7/V3-1/2020-06 | SICKOPERATING INSTRUCTIONS | TRANSIC111LP
Subject to change without notice
Contents
1 Important information ............................................................................ 10
1.1 Main operating information.......................................................................... 10
1.1.1 Installation location...................................................................... 11
1.2 Intended use ................................................................................................. 11
1.2.1 Purpose of the TRANSIC111LP.................................................... 11
1.3 Responsibility of user ................................................................................... 12
2 Product description ................................................................................. 13
2.1 Product identification ................................................................................... 13
2.2 Functional principle/measuring principle ................................................... 13
2.2.1 TRANSIC111LP probe design ...................................................... 13
2.3 TRANSIC111LP variants............................................................................... 14
2.3.1 Variant for in-situ-measurement.................................................. 14
2.3.2 Variant for extractive measurement............................................ 14
2.3.3 Variant for ambient gas measurement ....................................... 15
3 Installation................................................................................................16
3.1 Project planning............................................................................................ 16
3.1.1 Chemical tolerance ...................................................................... 16
3.1.2 Temperature conditions ............................................................... 16
3.1.3 Strong light sources near the oxygen measuring probe ............. 17
3.1.4 Pressure........................................................................................ 17
3.2 Installation .................................................................................................... 18
3.2.1 Safety information........................................................................ 18
3.2.2 Prerequisites for assembly .......................................................... 19
3.2.3 Installation angle.......................................................................... 19
3.3 Installation options ....................................................................................... 20
3.3.1 Process conditions for installation options ................................. 20
3.3.2 TRANSIC111LP installation for in-situ measurement
(with flange) .................................................................................. 20
3.3.3 TRANSIC111LP installation - extractive ...................................... 22
3.3.4 TRANSIC111LP installation – ambient gas measurements...... 25
3.4 Connections .................................................................................................. 26
3.4.1 Cabling of signal and voltage supply lines ................................. 26
3.4.2 Connecting the 24V PELV power supply unit ............................. 29
3.4.3 Connecting the TRANSIC111LP via an 8-pole plug connector... 29
3.4.4 Test gas connection (optional) .................................................... 30
To Next Page
Loading...
