SICK TRANSIC111LP - Display;Set Serial Communication Mode (Command SMODE); Display;Set Serial Communication Mode for RS-485 (Command SMODE2)

43
8014084/ZWT7/V3-1/2020-06 | SICK OPERATING INSTRUCTIONS | TRANSIC111LP
Subject to change without notice
OPERATION 4
4.7.5 Display/set serial communication mode (command SMODE)
Defines the mode of the serial interface via which the command is entered (maintenance
or RS-485 interface). Possible modes are STOP, POLL and RUN. Command SAVE (see “Save
parameters (command SAVE)”, page 58) saves the setting.
Syntax: SMODE [Mode]<cr>
Example:
4.7.6 Display/set serial communication mode for RS-485 (command SMODE2)
Defines the communication mode for the RS-485 interface. Possible modes are STOP,
POLL and RUN. Command SAVE (see “Save parameters (command SAVE)”, page 58) saves
the setting.
Syntax: SMODE2 [Mode]<cr>
Example:
Mode = Serial communication mode, possible modes are STOP, POLL and RUN
>smode
SMODE : STOP ?
>
Mode = Serial communication mode, possible modes are STOP, POLL and RUN
>smode2
SMODE : STOP ?
>