SICK TRANSIC111LP - Display Error Control Status (Command ERR); Display Error Protocol (Command ERRL); Errors; Reset (Command RESET)

59
8014084/ZWT7/V3-1/2020-06 | SICK OPERATING INSTRUCTIONS | TRANSIC111LP
Subject to change without notice
OPERATION 4
4.17 Resetting the measuring device
4.17.1 Reset (command RESET)
Resets the transmitter. This has the same effect as switching the transmitter off and on
again.
Syntax: RESET<cr>
Example:
4.17.2 Restore factory calibration (command FCRESTORE)
Open the Terminal program with the valid serial communication settings and enter the
command with password:
Syntax: FCRESTORE<cr>
Example:
4.18 Errors
4.18.1 Display error control status (command ERR)
Displays the error control status and active errors.
Syntax: ERR<cr>
Example:
4.18.2 Display Error protocol (command ERRL)
Displays the events in the Error protocol.
Syntax: ERRL<cr>
Example:
>reset
Resetting...
TRANSIC100LP 9165087 0000 / 1.36
SICK, 2011
...
>fcrestore
Customer calibration removed - remember SAVE command
Save the changes by issuing the command:
>save
>err
*** ERROR CONTROL (ERR) ***
Mode : ON
State : WARNING
ERRORS:
WARNING : WATCHDOG RESET OCCURRED
>
>err
*** ERROR CONTROL (ERR) ***
Mode : ON
State : WARNING
ERRORS:
WARNING : WATCHDOG RESET OCCURRED
>