94
8014084/ZWT7/V3-1/2020-06 | SICKOPERATING INSTRUCTIONS | TRANSIC111LP
Subject to change without notice
9 SHUTDOWN
9Shutdown
9.1 Safety information
● TRANSIC111LP: Open the display cover only for operation purposes. Never open the side
covers when voltage is switched on.
All safety regulations for shutdown can be found in Section Installation under “Installation”,
page 18 and in Section Maintenance under see “Safety information for assembly and
maintenance work”, page 84.
9.2 Preparations for shutdown
▸ Inform all connected locations.
▸ Passivate/deactivate the safety devices.
▸ Stop the inflow.
▸ Save the data.
9.3 Switching the TRANSIC111LP off
▸ Switch the TRANSIC111LP voltage supply off.
9.4 Protecting a shutdown TRANSIC111LP
▸ Store in a protected, dust-free and dry place.
▸ Observe the storage temperature (see “Ambient conditions”, page 101).
9.5 Disposal
▸ The TRANSIC111LP can easily be disassembled into its components which can then be
sent to the respective raw material recycling facilities.
▸ Dispose of the TRANSIC111LP as industrial waste.
9.6 Shipping the TRANSIC111LP to SICK
CAUTION: Never divert the laser beam
Never insert an optical instrument into the measuring gap to possibly divert the laser
beam whilst the TRANSIC111LP is switched on.
▸ Observe the respective valid local regulations for the disposal of industrial waste.
CAUTION: Hazard through process residues on the device
▸ Clean the TRANSIC111LP before shipping to SICK.
To Next Page
Loading...