SICK TRANSIC111LP - Display Product Name and Software Version (Command VERS); Display Status of Submenu Item (Command STATUS); Save Parameters (Command SAVE); Using Memory

58
8014084/ZWT7/V3-1/2020-06 | SICKOPERATING INSTRUCTIONS | TRANSIC111LP
Subject to change without notice
4 OPERATION
4.15.3 Display status of submenu item (command STATUS)
Displays the settings and status of all submenu items.
Syntax: STATUS<cr>
Example:
4.15.4 Display product name and software version (command VERS)
Displays the device name and software version.
Syntax: VERS<cr>
Example:
4.16 Using memory
4.16.1 Save parameters (command SAVE)
Saves the parameters from RAM to EEPROM.
Syntax: SAVE<cr>
Example:
>status
Submenu items are mode and status:
*** LASER TEMPERATURE CONTROLLER (LTC) ***
Mode : ON
State : TEMP_OK
*** OXYGEN MEASUREMENT (MEA) ***
Mode : MODE2
State : PEAK_LOCKED
Run Time Func.: OFF
*** ANALOG OUTPUT (OUT) ***
Mode : NORMAL
State : NORMAL
*** ERROR CONTROL (ERR) ***
Mode : ON
State : NO ERRORS
*** CUSTOMER INTERFACE (SCI2) ***:
Mode : STOP
*** SERVICE INTERFACE (SCI1) ***:
Mode : STOP
*** DISPLAY BOARD (DB) ***
Mode : NORMAL
State : NORMAL
>
>vers
TRANSIC100LP 9165087 0000 / 1.36>status
NOTICE:
Remember to save parameter changes with the command SAVE so that the changes
are not lost.
>save
EEPROM (basic) saved successfully
EEPROM (op) saved successfully
EEPROM (op_log1) saved successfully
EEPROM (op_log2) saved successfully