41
8014084/ZWT7/V3-1/2020-06 | SICK OPERATING INSTRUCTIONS | TRANSIC111LP
Subject to change without notice
OPERATION 4
SERI2 Display/define serial communication settings for RS-485
SIL Measure signal level
SMODE Display/set serial communication mode
SMODE2 Display/set serial communication mode for RS-485
STATS Display status information
TIME Display/set time
VERS Display product name and software version
XPRES Set pressure for compensation
Serial interface command Description
ADJUST Hold outputs for calibration
CO2 Display/set CO
2
for compensation
COXY1 Perform one-point adjustment
COXY2 Perform two-point adjustment
DB Display status of display range
ENV Set several/all ambient parameters with one command
ERR Display error control status
ERRL Display error protocol
ERRT Display error Table
FCRESTORE Reset factory calibration
H2O Display/set H
2
O for compensation
ICAL Calibrate analog output
ITEST Set test current for analog output
LTC Display status of laser temperature controller
MEA Display measuring status
OUT Display output status
OUT_PARAMS Display/set output parameters
PRES Display/set pressure for compensation
RELAY_MODE Display/set relay operating mode
RESET Reset device
RSEL Display/set relay switching point
SCI1 Display status of serial maintenance interface
SCI2 Display status of serial RS-485
STATUS Display status of submenu item
Table 6: List of additional serial interface commands with password
Serial interface command Description
Table 5: List of serial interface commands without password
To Next Page
Loading...
