SICK TRANSIC111LP - Page 6

CONTENTS
6
8014084/ZWT7/V3-1/2020-06 | SICKOPERATING INSTRUCTIONS | TRANSIC111LP
Subject to change without notice
4.7 Output of measuring results ........................................................................ 42
4.7.1 Start continuous output (command R)........................................ 42
4.7.2 Stop continuous output (command S) ........................................ 42
4.7.3 Display/set continuous output interval (command INTV) .......... 42
4.7.4 Send measuring results (command SEND)................................. 42
4.7.5 Display/set serial communication mode (command SMODE) ... 43
4.7.6 Display/set serial communication mode for RS-485
(command SMODE2).................................................................... 43
4.7.7 Display/define serial communication settings
(command SERI)........................................................................... 44
4.7.8 Display/set serial communication for RS-485
(command SERI2) ........................................................................ 44
4.7.9 Display status of serial maintenance interface
(command SCI1)........................................................................... 45
4.7.10 Display status of serial RS-485 interface (command SCI2)....... 45
4.7.11 Display measuring status (command MEA) ................................ 45
4.7.12 Format measuring results (command FORM) ............................. 45
4.7.13 Display/set date (command DATE) ............................................. 47
4.7.14 Display/set time (command TIME) .............................................. 47
4.8 Network operation ........................................................................................ 48
4.8.1 Display/set device address (command ADDR) ........................... 48
4.8.2 Open communication line (command OPEN).............................. 48
4.8.3 Close serial interface in Poll mode (command CLOSE) .............. 48
4.8.4 Set Echo mode (command ECHO) ............................................... 49
4.9 Commands for access at maintenance level .............................................. 50
4.9.1 Enter password (example PASS) ................................................. 50
4.10 Commands for calibration and adjustment................................................. 50
4.10.1 Hold outputs for calibration (command ADJUST) ....................... 50
4.10.2 Set water content for compensation (command H2O)............... 50
4.10.3 Set carbon dioxide content for compensation (command CO2) 51
4.10.4 Set several/all ambient parameters with one single command
(command ENV)............................................................................ 51
4.10.5 Calibrate analog output (command ICAL) ................................... 51
4.11 Scaling and setting the analog output......................................................... 52
4.11.1 Display/set output parameters (command OUT_PARAMS)........ 52
4.11.2 Display/set pressure for compensation (command PRES) ........ 52
4.12 Checking the analog output ......................................................................... 53
4.12.1 Set test current for analog output (command ITEST) ................. 53