SICK TRANSIC111LP - Page 8

CONTENTS
8
8014084/ZWT7/V3-1/2020-06 | SICKOPERATING INSTRUCTIONS | TRANSIC111LP
Subject to change without notice
6 Adjustment ............................................................................................... 65
6.1 Hardware preparations................................................................................. 65
6.1.1 Setting up the gas supply for calibration and adjustment ......... 66
6.1.1.1 Using ambient air...................................................... 66
6.1.1.2 Using bottled gas ...................................................... 66
6.1.2 Calibration and adjustment in the process................................. 67
6.1.2.1 Connections and systems ........................................ 67
6.1.2.2 Connecting the gas................................................... 67
6.1.2.3 Adjusting gas flow..................................................... 68
6.1.3 Information on calibration gases................................................. 68
6.2 Calibration..................................................................................................... 69
6.2.1 Using ambient air ......................................................................... 69
6.2.2 Using bottled gas.......................................................................... 70
6.3 Adjustment.................................................................................................... 71
6.3.1 Adjustment process ..................................................................... 71
6.3.2 Adjustment options ...................................................................... 71
6.3.3 One-point adjustment via the serial interface
(command COXY1) ....................................................................... 72
6.3.4 One-point adjustment using the keypad (function CAL1)........... 73
6.3.5 Two-point adjustment via the serial interface
(command COXY2) ....................................................................... 74
6.3.6 Two-point adjustment using the keypad (function CAL2)........... 76
6.4 TRANSIC111LP adjustment for ambient gas measurement ...................... 78
6.4.1 Setting up the gas supply ............................................................ 78
6.4.2 Calibration .................................................................................... 79
6.4.2.1 Using ambient air...................................................... 79
6.4.2.2 Using calibration gas ................................................ 79
6.4.2.3 Information on calibration gases ............................. 79
6.4.3 Calibration method....................................................................... 80
6.4.4 Information on adjustment .......................................................... 80
6.4.5 Adjustment ................................................................................... 80
6.4.6 Adjustment options ...................................................................... 80
6.4.7 One-point adjustment via the serial interface ............................ 81
6.4.8 One-point adjustment via the serial interface
(command COXY1) ....................................................................... 81
6.4.9 One-point adjustment using the keypad (function CAL1)........... 83
6.4.10 Restoring factory calibration........................................................ 83