EasyManuals Logo

Siemens MCP 398C Commissioning Manual

Siemens MCP 398C
1734 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1125 background imageLoading...
Page #1125 background image
Note
If errors occur when reading and writing drive parameters, the screen property ERR is set
appropriately.
Programming
Syntax: RDOP
("Identifier of the drive object", "Parameter number")
Description: Reading a drive parameter (Drive Object Parameter)
Parameter: Identifier of the drive object The identifier of the drive object
can be found in the "DO name"
column in "Drive system diag‐
nostics" in the diagnostics oper‐
ating area ( > ETC > HSK 8: drive
system) (see diagram below).
Parameter number
Figure 6-1 Identifier of the drive object
Syntax: MRDOP
("Identifier of the drive object", "Parameter number1"*"Pa‐
rameter number"[*…], Register index)
Description: Multi-read of drive parameters.
The MRDOP command transfers several drive parameters or drive
objects in a single register access. This access method is signifi‐
cantly faster than reading via individual access attempts.
Programming commands
6.3 Functions
SINUMERIK Integrate Run MyScreens (BE2)
Programming Manual, 12/2017, 6FC5397-1DP40-6BA1 139

Table of Contents

Other manuals for Siemens MCP 398C

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens MCP 398C and is the answer not in the manual?

Siemens MCP 398C Specifications

General IconGeneral
BrandSiemens
ModelMCP 398C
CategoryControl Systems
LanguageEnglish

Related product manuals