References
For a detailed description, please refer to the following documentation:
CNC Commissioning Manual: NCK, PLC, drive; Chapter "Licensing"
Deactivate options
When importing old archives from other HMI systems, it can occur that options are set which
are no longer required in the actual system – however, these are subject to the license check:
Order number Option
6FC5800-0AP04-0YB0 Machining step programming
6FC5800-0AP11-0YB0 Manual machine
6FC5800-0AP15-0YB0 ShopTurn HMI/ShopMill HMI for SINUMERIK 840Di sl incl. HMI-
Advanced
6FC5800-0AP20-0YB0 3D simulation of the finished part
6FC5800-0AP21-0YB0 Simulation, milling (2D dynamic; 3D static)
6FC5800-0AP23-0YB0 Simultaneous recording, ShopMill (real-time simulation)
6FC5800-0AP24-0YB0 Simultaneous recording, ShopTurn (real-time simulation)
4.1 Determining the license requirement
Procedure
1. Press the "All options" softkey to list all the options that can be selected
for this controller.
- OR -
Press the "Missing lic./opt." softkey.
You receive an overview of all options that
● are not adequately licensed
● are licensed, but which have not been set
2. Activate or deactivate the required options in the "Set" column:
● Activate the checkbox or
● Enter the number of options.
Options shown in red are activated, however, not yet licensed or not ad‐
equately licensed.
- OR -
Press the "Set option acc. to license" softkey to activate all of the options
contained in the license key.
You obtain a confirmation prompt that you must confirm with "OK".
Licensing
4.1 Determining the license requirement
SINUMERIK Operate (IM9)
74 Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
To Next Page
Loading...
Need help?
General
