EasyManuals Logo

Siemens MCP 398C Commissioning Manual

Siemens MCP 398C
1734 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1415 background imageLoading...
Page #1415 background image
Appendix
A
A.1 Abbreviations
CF CompactFlash card: Memory card
CFS Cluster File System
CIFS Common Internet File System
DCK Direct Control Keys: Direct control keys
DCP Discovery and Basic Configuration Protocol
DHCP Dynamic Host Configuration Protocol: Dynamic assignment of an IP address and other configuration pa‐
rameters on a computer in a network
DNS Domain Name System: Conversion of domain names into IP addresses
EBS Emergency Boot System
EKS Electronic Key System: System to check the identity of a user (authentication system)
EUNA End User Notification Administration
HMI Human Machine Interface: Operator interface
IRT Isochronous Realtime (Ethernet)
LLDP Link Layer Discovery Protocol: multi-vendor Layer 2 Protocol defined in accordance with the IEEE-802.1AB
standard, allows information to be exchanged between devices.
MAC Media Access Control: The MAC address is a 48-bit Ethernet ID.
MCP Machine Control Panel: Machine control panel
MPI Multi-Point Interface: Multiple interface
MUI Multilanguage User Interface
NAT Network Address Translation
NCK Numerical Control Kernel: NC kernel with block preparation, travel range, etc.
NCU Numerical Control Unit: NCK hardware unit
NFS Network File Service is a network protocol.
NRT Non-Realtime (Ethernet)
NTFS New Technology File System
NTLMSSP NT LAN Manager (NTLM) Security Support Provider
NTP Network Time Protocol: Standard for synchronizing clocks in the entire network
NTPD NTP Daemon:
Utility that runs in the background and does not have to be started by the user.
PCU PC Unit: Computer unit
PDEV Physical device
PG Programming device
PLC Programmable Logic Control: Programmable logic controller
RAM Random Access Memory: Program memory which can be read and written into
RDY Ready: The system is ready to operate.
RFC Remote Function Call
SMB Server Message Block
NCU operating system
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1 97

Table of Contents

Other manuals for Siemens MCP 398C

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens MCP 398C and is the answer not in the manual?

Siemens MCP 398C Specifications

General IconGeneral
BrandSiemens
ModelMCP 398C
CategoryControl Systems
LanguageEnglish

Related product manuals