4.15.3 Configuring SITOP software for PCU Base Software
4.15.3.1 Configuring SITOP software V3.x (USB)
Configuring SITOP software V3.x (USB)
If you want to use a SITOP UPS module in combination with the PCU base software, you must
first adapt the settings of the SITOP software.
Requirement
● The SITOP UPS hardware is connected via the USB interface.
● The SITOP software of version 3.x.2.16 or later is installed in directory C:\Program
Files (x86)\SITOP\
Configuration of the system
4.15 Configuring the SITOP UPS module for use with the PCU Base Software
PCU Base Software (IM10)
54 Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
To Next Page
Loading...
Need help?
General
