10.3.9 Clamping system: Diagnostic statistics................................................................................158
10.3.10 Clamping system: Clamping time statistics..........................................................................159
10.3.11 Fetching the logistics data....................................................................................................159
11 Drive system.............................................................................................................................................161
11.1 Commissioning of drives .....................................................................................................161
12 Tool management.....................................................................................................................................163
12.1 Machine data for tool management......................................................................................163
12.1.1 Settings with/without magazine management......................................................................163
12.1.2 Configuring the access levels of the tool management........................................................164
12.1.3 Additional settings................................................................................................................166
12.2 Configuring the user interface..............................................................................................169
12.2.1 General settings...................................................................................................................172
12.2.2 Configuring tool lists.............................................................................................................177
12.2.2.1 Tool parameter identifiers....................................................................................................181
12.2.2.2 Cutting edge parameter identifiers.......................................................................................183
12.2.2.3 Monitoring parameter identifiers...........................................................................................186
12.2.2.4 Grinding parameter identifiers..............................................................................................187
12.2.2.5 Magazine location parameter identifiers..............................................................................188
12.2.2.6 Magazine location adapter parameter identifiers.................................................................189
12.2.2.7 Multitool parameter identifiers..............................................................................................189
12.2.2.8 Multitool location parameter identifiers.................................................................................190
12.2.3 Configuring list parameters..................................................................................................191
12.2.4 List of tool types...................................................................................................................195
12.2.5 Configure tool types.............................................................................................................197
12.2.6 Configuring the "Additional Data" window............................................................................199
12.2.7 Configure the "New tool - favorites" window........................................................................201
12.2.8 Configuring the "New Tool" window.....................................................................................202
12.2.9 Configuring the "New Multitool" window...............................................................................202
12.2.10 Configuring the "New Tool from Code Carrier" window.......................................................203
12.2.11 Configuring the "New Tool from File" window......................................................................203
12.2.12 Configuring default values for new tools..............................................................................204
12.2.13 Configuring the "Details" window.........................................................................................208
12.2.14 Assigning a name for magazines and magazine locations..................................................208
12.2.15 Configuring the "Assign Tooltips for Multitool Locations" window........................................210
12.2.16 Assigning a name for magazine location types....................................................................211
12.2.17 Assignment of magazines and magazine locations to channels..........................................212
12.2.18 Assignment between magazines and magazine locations and coordinate systems............214
12.2.19 Disabling the softkey depending on filters............................................................................215
12.2.20 Configuring the "Load Station Selection" window................................................................216
12.2.21 Coolant and tool-specific functions......................................................................................217
12.2.22 Reason for the tool change when reactivating.....................................................................220
12.2.23 Configure the code carrier connection.................................................................................224
12.2.24 Configuring Save to file........................................................................................................227
12.3 Creating OEM texts..............................................................................................................228
12.3.1 Identifiers of the standard texts............................................................................................229
12.3.2 Examples of OEM texts........................................................................................................232
12.4 Examples.............................................................................................................................234
12.4.1 Example: Configuring an OEM tool list................................................................................234
12.4.1.1 Adapting the configuration file..............................................................................................234
Table of contents
SINUMERIK Operate (IM9)
8 Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
To Next Page
Loading...
Need help?
General
