Siemens MCP 398C Commissioning Manual

Example 1
The following example uses the texts for the tool change reason, already prepared in the
operating software. In this example, the tool change reason is stored in parameters that still
have to be configured, e.g. the OEM tool data 1, bit 1 and following.
<TOOLCHANGEREASON>
<Enabled value="true" type="bool" />
<REASON1>
<Text value="TM_DGL_DESIRED_PIECES_ELAPSED" type="QString" />
<Parameter value="ToolUser_1_Bit1" type="QString" />
</REASON1>
<REASON2>
<Text value="TM_DGL_TOOL_BREAKAGE" type="QString" />
<Parameter value="ToolUser_1_Bit2" type="QString" />
</REASON2>
<REASON3>
<Text value="TM_DGL_CUTTING_EDGE_DAMAGE" type="QString" />
<Parameter value="ToolUser_1_Bit3" type="QString" />
</REASON3>
<REASON4>
<Text value="TM_DGL_PREMATURE_WEAR" type="QString" />
<Parameter value="ToolUser_1_Bit4" type="QString" />
</REASON4>
<REASON5>
<Text value="TM_DGL_TYPE_REEQUIPPING" type="QString" />
<Parameter value="ToolUser_1_Bit5" type="QString" />
</REASON5>
<REASON6>
<Text value="TM_DGL_TOOL_TRIAL" type="QString" />
<Parameter value="ToolUser_1_Bit6" type="QString" />
</REASON6>
<REASON7>
<Text value="TM_DGL_PREVENTIVE_CHANGE" type="QString" />
<Parameter value="ToolUser_1_Bit7" type="QString" />
</REASON7>
</TOOLCHANGEREASON>
Example 2
Also in this example, the prepared texts for the reason for the change are used. It is only
permitted to enter one reason for the change as a valid entry. The reason for the tool change
is saved in the local variable of the SlCap service.
<TOOLCHANGEREASON>
<Enabled value="true" type="bool" />
Tool management
12.2 Configuring the user interface
SINUMERIK Operate (IM9)
222 Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1

Siemens MCP 398C Specifications

General

Brand	Siemens
Model	MCP 398C
Category	Control Systems
Language	English