3. Press the <Cursor right> or <INPUT> key.
The input window for the element settings opens.
4. Enter the desired changes and press the "OK" softkey to confirm the en‐
tries.
Note
You define the number of buffer and magazine locations in the input window of the higher-level
<Magazine> folder element with the "Locations" parameter.
Activating Data
1. Press the "Activate data" softkey.
All changed parameterizations are transferred to the NC and activated.
All of the error messages are displayed again, and you have the option
of specifically resolving these by modifying the data.
Note
Once you have made changes to the tool management, the data is marked with "*". This data
is not yet in the NC and so does not have any effect.
If you want to create a tool management that is similar to an already existing element, then
you can save time if you copy the existing elements and insert them at a different position.
You have the option, for example of also copying inactive subtrees into the active tree.
Copying/cutting and pasting elements
1. Position the cursor on the desired element.
2. Press the "Copy" softkey.
- OR -
Press the "Cut" softkey.
3. Position the cursor at the required position and press the "Paste" softkey.
If the element exists already at the desired location, you receive further
insertion options.
4. Press the "OK" softkey if you wish to attach the element to the tree view
as the next element.
The element is inserted.
Note:
You have the option of changing the name of the element in the associ‐
ated input window.
Tool management
12.6 Editor for the tool and magazine management
SINUMERIK Operate (IM9)
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1 247
To Next Page
Loading...
Need help?
General
