1. At the beginning of each chapter for variable sections, you find the information "OEM-MMC:
LinkItem“ specifying "/ToolCompensation/“.
2. Refer to the document and search for "ChannelCompensation" and then navigate manually
to the requested parameter "cuttEdgeParam".
Example 3: Finding a variable from documentation on OPC UA client
You want to find the variable "cuttEdgeParam" in the Tool edge data section.
1. At the beginning of each chapter of the variable documentation you find the information
"OEM-MMC: LinkItem" specifying here "/ToolCompensation/".
2. Therefore you will find the variable "cuttEdgeParam" in the OPC UA Browse Tree in the
folder "Tool", subfolder "Compensation".
Functionality
5.3 Variable access
SINUMERIK Integrate for Engineering Access MyMachine / OPC UA
44 Configuration Manual, 12/2017, 6FC5397-1DP40-6BA1
To Next Page
Loading...
Need help?
General
