Operator control
8.2 Operator input steps
SENTRON PAC3200
Manual, 02/2008, A5E01168664B-04
123
Selecting from several settings
F2
scrolls up through the range of selectable settings.
F3
scrolls down through the range of selectable settings.
Figure 8-22 Selecting from several settings
Incrementing or decrementing a value
F2
increases the value in increments of 1.
F3
decreases the value in decrements of 1.
The highest value of the available set of values is followed again by the lowest.
Defining multi-digit values
If F3
is available, the digits of a value can be changed, e.g. specific address digits of
an address value.
F3
runs through the digits of the value from left to right.
F2
increments the value at the selected digit. The highest value of the available set of
values is followed again by the lowest.
Figure 8-23 Defining multi-digit values
Saving the value
F4 saves the set value and returns to display mode.
Canceling editing
F1 cancels editing and returns to display mode. All changes are discarded.
Figure 8-24 Exiting edit mode
To Next Page
Loading...
