Siemens SENTRON PAC3200 - 7.3 Parameterizing the device; 7.4 LANGUAGE;REGIONAL

Startup
7.3 Parameterizing the device
SENTRON PAC3200
Manual, 02/2008, A5E01168664B-04
93
7.3 Parameterizing the device
Procedure for parameterizing
To start up the device, you must specify the operating parameters listed below in the device
settings:
● Connection type
● Voltage
– Direct measurement on the system or using voltage transformers
– Measuring input voltage in the case of direct measurement on the system
– Primary and secondary voltage when measuring using voltage transformers
● Current
– Primary and secondary current
The following settings are also useful:
● Language
● Password protection
See also
Password management (Page 150)
7.4 LANGUAGE/REGIONAL
7.4.1 Setting the language
First, set the language in which the display text is to appear.
The available languages are displayed:
● at initial startup,
● after resetting to factory settings, and
● after updating the firmware.
English is the default language.
Figure 7-1 Language selection
Select the desired language by pressing <F2> or <F3> .
Apply the desired language with <F4>
.