Installation
5.5 Deinstalling
SENTRON PAC3200
72 Manual, 02/2008, A5E01168664B-04
5.5 Deinstalling
Tools
You require the following tools to deinstall the device:
● PH2 screwdriver
● Slotted screwdriver
Deinstallation steps
1. Discharge any static from your body in accordance with the ESD guidelines.
CAUTION
Electrostatic sensitive devices
Ground your body! Discharge your body of any static electricity!
2. Start deinstallation on the inside of the switching panel.
3. Release the clamping arrangement on the switching panel. To do so, unscrew the four
screws on the two brackets. Leave the screws in the brackets.
4. Hold the bracket as shown in the figure "Deinstallation".
CAUTION
Mechanical tension
When releasing the locking hooks, the bracket may spring outwards from the device.
5. Carefully lever the locking hooks open with the slotted screwdriver or another suitable
tool. The bracket releases immediately.
6. Go to the outside of the switching panel and remove the device from the cutout.
7. Pack the device into the original box together with the operating instructions and the
delivered components listed in the operating instructions.
Deinstallation is complete.
Figure 5-2 Deinstallation, releasing the locking hooks
To Next Page
Loading...
