Siemens SENTRON PAC3200 - Figure 3-5 Representation of Limit Violations

Description
3.6 Limits
SENTRON PAC3200
Manual, 02/2008, A5E01168664B-04
35
The placeholder "----" means: This limit value is not combined with any other limit value.
The logic combines limit values 0 to 5 as follows:
(((((op
LIM0
LIM0 op
LIM1
LIM1) op
LIM2
LIM2) op
LIM3
LIM3) op
LIM4
LIM4) op
LIM5
LIM5)
LIM0 represents limit value 0
LIM1 represents limit value 1
LIMx represents limit value x
op represents the logic operator AND/OR in the formula
The brackets in the formula show that the AND/OR priority rule does not apply.
The result of the logic operation is the "LIMIT LOGIC".
Displaying limit violations
● Indication of limit violation on the display:
"MAIN MENU> SETTINGS > ADVANCED > LIMITS" and
"... > LIMITS > LIMIT LOGIC".

Figure 3-5 Representation of limit violations
(1) Limit value designation
(2) Monitored data source
(3) Limit value currently violated: Yes
, No
● Outputting the limit violation to the digital output.
● Output of limit violations via the interface.
● Counting limit violations with the universal counter.