Siemens SENTRON PAC3200 - Operator Input Steps in Edit Mode of the Device Settings

Operator control
8.2 Operator input steps
SENTRON PAC3200
122 Manual, 02/2008, A5E01168664B-04
8.2.5 Operator input steps in edit mode of the device settings
Enter password
If device protection is switched on, the SENTRON PAC3200 demands input of the valid
password.
Figure 8-19 Enter password
You can find information on password management in the "Password management" chapter.
Change value
Switching a device setting ON/OFF
F4
switches a function or status ON/OFF. The setting takes effect immediately. Saving
with F4
no longer applies.
Figure 8-20 Switching a device setting ON/OFF
Switching between several options
F4
switches between options that cannot be in effect at the same time. When an
option is switched on, the last valid option is switched off.
The setting takes effect immediately. Saving with F4
no longer applies.
Figure 8-21 Device setting, switching between several alternatives