Siemens SENTRON PAC3200 - Page 153

Parameterize
9.2 Parameterizing the operator interface
SENTRON PAC3200
Manual, 02/2008, A5E01168664B-04
153
To change the password:
1. Call the "PASSWORD PROTECTION" display.
2. Go to the "PASSWORD" device setting:
F2
or F3
3. Open edit mode of the "PASSWORD" device setting:
F4
4. Change the password with:
F2
and F3
5. Accept the new password with:
F4
The password is permanently saved and becomes effective immediately.
The display returns to display mode.
Figure 9-26 Change password
Initial situation: Password protection switched on:
If password protection is switched on, the valid password must be entered in order to change
the password.
To change the password:
1. Call the "PASSWORD PROTECTION" display.
2. Go to the "PASSWORD" device setting:
F2
or F3
3. Open edit mode of the "PASSWORD" device setting:
F4
4. The device opens the "ENTER PASSWORD" dialog box.
5. Enter the password and confirm with
F4
If you have entered the correct password, the password becomes visible in the
PASSWORD field.
6. Open edit mode of the device setting "PASSWORD" with:
F4
7. Change the password with:
F2
and F3
8. Accept the new password with:
F4
The password is permanently saved and becomes effective immediately.